Code Grabber P24 Pandora D605, Keyless Go Repeaters, Car Jammers

How does Code Grabber Pandora DXL 5000 work?

How does Code Grabber Pandora DXL 5000 work


Please read instruction of how does Code Grabber Pandora DXL5000 works below.
You can buy Code Grabber DXL 5000 here.

How Does Code Grabber Pandora DXL 5000 works

How to turn on Code Grabber Pandora DXL 5000?

Hold button 5 until the beep sounds, then enter the password.

You can enter the password using buttons 1 (1st and subsequent digits), button 2 (confirmation of each dialed digit). There are only 10 entry attempts, after which the appliance will be blocked, if it is incorrectly dialed.

Description of buttons for Code Grabber DXL 5000

Button 5 – short-switching modes, long-on-off device, hold up to peak-on-off back light

Button 4 — short-switching memory banks, long-switching frequencies 315-433

Button 3 —- short on-off reception, long-erase. Hold in an empty bank until the first peak, this is the inclusion of the mode – block re-code-

Button 2—- short-open, long-catch-up of the code, if in an empty bank with the reception turned on for a long time, then enter the menu of control modes

in this menu 2 button briefly select the modes, and 1 button briefly turn them on or off, exit the control menu by holding 2 button.

Button 1 —- short-close, long-open trunk, if in an empty bank with the reception on for a long time, then the input-output is in three operating states,

Only 1.5 and 6 modes will work.

If you need to save any of the signals in Code Grabber Pandora DXL 5000 – go to another memory bank BRIEFLY by pressing button 4. After this the signal is automatically saved in the cell, in which it was caught.

Mode management for DXL 5000

Mode management. It’s not convenient for many users to switch a bunch of modes that they don’t use for a while. That is why there’s the decision to turn on exactly those modes that are needed. The others can be temporarily turned off. You can do this by holding button 2 in an empty bank. While the red light comes on, by short pressing on button 2 select unnecessary modes. Turn them off by button 1. Or you can turn them on when the mode is turned off the box opposite the digit of the selected mode disappears. After selecting the active modes, you need to exit the menu of mode selection by also holding button 2.

After which only those modes that were selected will work! There is also an emergency switch from 7 modes to 3 modes with one touch. If in an empty bank with the reception on hold button 1, then 3 modes will turn on — that’s 1.5.6 …. Also, by holding button 1, you can exit 3 operating modes!

SECURITY — Home mode function. Received signal at 10 cell when the device is turned off, works with the car whose signal was recorded in this cell.

For convenience, using the switching modes, each press on button 5 is accompanied by vibrating, and when turned on 7 mode, double vibrating, so that it was more convenient to count the modes without seeing the key chain!

How to switch off Code Grabber Pandora DXL 5000?

Shutdown: Hold button 5 <> until vibration is triggered.

NOTE: explanations of what is re-code lock! The same signal recorded in the memory cell is not recorded a second time, but accompanied a short signal, meaning that this signal already exists in some of the memory cells! Power is enough for 4.5 hours of work. Recorded signals in different modes, you can use to open while in any of the modes. Reception of full-time trinkets, especially VAG and FORD, are accepted stably not further than from 15 meters, and from 20-25 meters – unstable

ATTENTION! The manufacturer is not responsible for the likelihood of a complete blockage of the device, since blocking can only occur through fault user with ten times the wrong password. In this case, the device cannot be restored, replaced or returned. Also not subject replacement, return and repair in case of attempt to open the rear cover of the key fob.

PS.

WHEN YOU CHOOSE THE DISTANCE FOR THE SCAN OF THE CAR, DO NOT FORGET THAT IN STATE KEYS THE OWNERS RARELY CHANGE THE BATTERY. THAT IS WHY, WHEN CLOSING A CAR WITH A LOW BATTERY, THE SIGNAL DOES NOT FLY AWAY. SO WHEN IT IS PREFERRED TO BE CLOSER TO THE CAR.

Contact me in Telegram for all questions: https://t.me/UnlockCars

Code Grabber Channel: https://t.me/UnlockCars_Grabber

IMPORTANT !!! WE SELL ALL DEVICES FOR OFFICIAL USE ONLY !!!
!!! THE MANUFACTURER IS NOT RESPONSIBLE FOR ILLEGAL ACTIONS BY THE BUYERS !!!

Leave a Reply

Your email address will not be published. Required fields are marked *

error: Contact us via Telegram: @UnlockCars